Clear failures from the phase control screen

  1. Click the Phase Control button to open the Phase Control screen.
  2. Click the Display Units button.
    Note

    If the unit has an MMI picture defined, the unit is marked with an asterisk.

  3. Select the unit in the graphical display to which the failed phase belongs.
  4. Click the Phase button of the failed phase.
  5. If the batch that owns the failed phase has been removed from the batch list and you do not already own the phase, acquire the phase.
  6. Start the phase, to enable the Clear All Failures button.
  7. Click the Clear All Failures button from the Commands button bar.
  8. If you are prompted for confirmation, click Yes to clear the failures or No to cancel.
  9. Click the Restart button to restart the phase.
  10. Reset the phase.
  11. Release the phase.
    Note

    The operator can only clear failed phases from the Phase Control screen if the batch that owns the failed phase has been removed from the batch list or if the operator has already acquired ownership of the phase.

Related information