Modifying the motor module - overview

Finish configuring the MTR-101 module

  1. Assign the MTR-101 module to the primary control picture TANK101. (Remember, you enter the name of the primary control picture on the Displays tab of the Properties dialog for the module. Also remember that the TANK101 picture does not exist yet. You will create it later.)

    Note that this module has two predefined pictures: DL_DT8 is the detail display and DL_FP is the faceplate.

  2. Change the Detail to DL_DT3 to match the number of conditions. (Remember, in a previous topic you removed the five unused condition blocks.)
  3. Assign the control module to the controller.
  4. Save the control module by clicking the Save button. (The module has already been named.)
  5. Minimize Control Studio by clicking the Minimize button in the upper right corner.