Simplex Analog Input 48-Pin Mass Terminal Block specifications

Installation notes

This terminal block is used to terminate wiring for the S-series simplex AI 16-channel 4-20 mA HART Plus card. Set the terminal block key to A6 before installing the card.
The mass terminal block has two, 24-pin IDC headers that split the 16 channels into two, 8-channel headers. Each of the two-row headers accept a 24-pin 1-for-1 passthrough cable with 2x12 header connectors. The assembly can interface to a feed-through IDC to analog wire module such as the Phoenix Contact FLKM20 VARIOFACE ribbon connector module. It can also interface to the Pepperl+Fuchs HiD Series Boards if IS Barriers are required. The Phoenix Contact FLKM20 VARIOFACE ribbon connector module and the Pepperl+Fuchs HiD Series Boards are Emerson Alliance Program products.

Table: Simplex Analog Input 48-Pin Mass Terminal Block cable pin outs
Inner J3	Signal	Outer J4	Signal
Pin 1	Channel 1-	Pin 1	Channel 9-
Pin 2	Channel 1+	Pin 2	Channel 9+
Pin 3	Channel 2-	Pin 3	Channel 10-
Pin 4	Channel 2+	Pin 4	Channel 10+
Pin 5	Channel 3-	Pin 5	Channel 11-
Pin 6	Channel 3+	Pin 6	Channel 11+
Pin 7	Channel 4-	Pin 7	Channel 12-
Pin 8	Channel 4+	Pin 8	Channel 12+
Pin 9	Channel 5-	Pin 9	Channel 13-
Pin 10	Channel 5+	Pin 10	Channel 13+
Pin 11	Channel 6-	Pin 11	Channel 14-
Pin 12	Channel 6+	Pin 12	Channel 14+
Pin 13	Channel 7-	Pin 13	Channel 15-
Pin 14	Channel 7+	Pin 14	Channel 15+
Pin 15	Channel 8-	Pin 15	Channel 16-
Pin 16	Channel 8+	Pin 16	Channel 16+
Pin 17	4-wire channel 1	Pin 17	4-wire channel 9
Pin 18	4-wire channel 2	Pin 18	4-wire channel 10
Pin 19	4-wire channel 3	Pin 19	4-wire channel 11
Pin 20	4-wire channel 4	Pin 20	4-wire channel 12
Pin 21	4-wire channel 5	Pin 21	4-wire channel 13
Pin 22	4-wire channel 6	Pin 22	4-wire channel 14
Pin 23	4-wire channel 7	Pin 23	4-wire channel 15
Pin 24	4-wire channel 8	Pin 24	4-wire channel 16