Vibration may cause carrier connectors to disconnect from each other. Install a DIN Rail Stop at each end of the carriers on each DIN rail to prevent carriers from disconnecting.
- Be sure the arrow on the top of the DIN Rail Stop is pointing towards the carrier. This prevents damage from the screws on the DIN Rail Stop.
- Hook the end with the deeper notch over the DIN rail and then hook the end with the more shallow notch over the other side of the DIN rail.
- Screw the DIN Rail Stop onto the DIN rail being careful not to overtighten the screws. Be sure that both sides of the DIN Rail Stop are properly secured. The torque limits are specified on the DIN Rail Stop.