This pane contains information about the ports of the selected commissioned switch.
| Column | Description |
|---|---|
| Port | The port number in m.p format where m is the module number (1 though 7 depending on device's model) and p is the port number. |
| Enabled | Indicates if the port is enabled. |
| Node Name | Name of the DeltaV node connected to the port. |
| Learned Address | Blank if the device is Unlocked. If Locked and the port is Enabled, displays the MAC address of daisy-chained devices; or, the MAC Address or IP address of single expected device. If Locked and the port is Disabled, displays (None). |
| Port Locking Violation | Specifies whether there's a port locking violation on the port or not. |
The information that appears for ports depends on the current state of the port. The states and the information that appears for each state is summarized in the table.
| Port State | Port Information Columns | |||||
|---|---|---|---|---|---|---|
| Lock Status | MAC Addresses Accepted1 | MAC Addresses Attempting to Connect | Enabled2 | Node Name | Learned Address | Port Locking Violation |
| Unlocked | All | None | Yes | (Idle) | blank | No |
| All | One | Yes | (One active) | blank | No | |
| All | More than one | Yes | (Multiple active) | blank | No | |
| Locked | 0 | None | No | blank | (None) | No |
| 0 | One or more | No | UNKNOWN | (None) | Yes | |
| 1 | None | Yes | Disconnected | MAC Address | No | |
| 1 | One or more | Yes | UNKNOWN | MAC Address | Yes | |
| 1 | Only the originally connected MAC address | Yes | Name of the connected DeltaV node or IP address | IP Address | No | |
|
1 For Locked ports 0 means the port was not connected when the switch was locked; 1 means the port was connected when the switch was locked. 2 Ports are disabled when switches are locked if no communications were (recently) detected on that port since the switch was last locked. |
||||||
| Notation | Description |
|---|---|
| U | The port is an uplink port when the port number is followed by the U character. |
| O | The port is excluded from the port lockdown algorithm by the user when the port number is followed by the O character. |
| P | The port is a probe port (used for port mirroring) when the port number is followed by the P character. |
From this pane, you can double click a port to open the Port Statistics dialog or right click and select one of the following: