The command button bar

Many of the Batch Operator Interface screens have a set of command buttons that are used to issue commands to the current batch. This set of buttons is located on the right side of the screen.

The buttons are not always active or available. The buttons and their availability change dynamically, depending on the function of a particular screen and the current state of the batch. For example, to avoid the inadvertent removal of an active batch, the Remove Batch button is available only if there are batches in the Batch List in either the Stopped or Ready states.

The following table lists the Command buttons.

Table: Command Buttons
Click this icon...	To...
	Start the batch.
	Hold the batch.
	Restart the batch.
	Abort the batch.
	Stop the batch or step.
	Switch to MANUAL mode.
	Switch to AUTOMATIC mode.
	Add a batch.
	Perform an active step change.
	Acquire/add a step.
	Release/remove a step.
	Reset a step.
	Pause the execution of the batch.
	Resume the execution of the batch.
	Remove a batch.
	Clear all failed phases that appear in the Alarm Summary screen.
	Reruns the step.
	Select equipment (Rebind) Note Batch must be in MANUAL mode before the paper clip button is active.