Change an on-line SIS parameter with Electronic Signature enabled

This procedure assumes:
  • An SIS module is assigned to a Logic Solver that is assigned to a simulated Logic Solver Card under the ProfessionalPLUS workstation.
  • The module is open in Debug mode in Control Studio.
  • The module has an Electronic Signature Policy defined.
  1. Navigate to a block in the SIS module and select a parameter.
  2. Right-click, and then select Force Input.
  3. Enter a value in the Parameter Properties dialog, and then click OK.
  4. Enter a User Name, Password, and Comment in the Electronic Signature dialog, and then click OK.
  5. Click Confirm in the Confirmation dialog.