Edit an equipment module containing an SIS module

This example assumes that an equipment module containing an SIS module is open in Control Studio and that you have the CanConfigure function key.

  1. Select a module block that is bound to an SIS module.
  2. Right-click, and then select Show Parameter.

    The Input and Output radio buttons are grayed out. Output is selected because it is the only valid selection for a module block that references an SIS module.

  3. Click the Browse button.

    The Browse dialog lists the valid output parameters for the SIS block.

  4. Select a parameter, and then click OK.
  5. Click OK.

    The output parameter is displayed on the SIS module block.