A standard installation uses one carrier extender cable; however, dual carrier extender cables can also be used. The following procedure is for a standard installation that uses one carrier extender cable.
Install the right and left-side one-wide carriers by sliding together the 48 pin connectors on the sides of the carriers.
Figure: One-wide carriers
Connect the 44 pin D-shell (male) connector on the carrier extender cable to the top D-shell connector labeled A on the right-side carrier and fasten the retainer screws.
Connect the 44 pin D-shell connector on the other end of the cable to the top D-shell connector labeled A on the left-side carrier and fasten the retainer screws.
