Simplex Analog Output 48-Pin Mass Terminal Block specifications

Installation Notes

This terminal block is used to terminate wiring for an M-series simplex AO 16-channel 4-20 mA HART Plus card. Set the terminal block key to A5 before installing the card.
The mass terminal block has two 24-pin IDC headers that split the 16 channels into two 8-channel headers. Each of the two-row headers accept a 24-pin 1-for-1 passthrough cable with 2x12 header connectors. The assembly can interface to a feed-through IDC to analog wire module such as the Phoenix Contact FLKM20 VARIOFACE ribbon connector module. It can also interface to the Pepperl+Fuchs HiD Series Boards if IS Barriers are required. The Phoenix Contact FLKM20 VARIOFACE ribbon connector module and the Pepperl+Fuchs HiD Series Boards are Emerson Alliance Program products.

Table: Simplex Analog Output 48-Pin Mass Terminal Block cable pin outs
Inner J2	Signal	Outer J3	Signal
Pin 1	Channel 1-	Pin 1	Channel 9-
Pin 2	Channel 1+	Pin 2	Channel 9+
Pin 3	Channel 2-	Pin 3	Channel 10-
Pin 4	Channel 2+	Pin 4	Channel 10+
Pin 5	Channel 3-	Pin 5	Channel 11-
Pin 6	Channel 3+	Pin 6	Channel 11+
Pin 7	Channel 4-	Pin 7	Channel 12-
Pin 8	Channel 4+	Pin 8	Channel 12+
Pin 9	Channel 5-	Pin 9	Channel 13-
Pin 10	Channel 5+	Pin 10	Channel 13+
Pin 11	Channel 6-	Pin 11	Channel 14-
Pin 12	Channel 6+	Pin 12	Channel 14+
Pin 13	Channel 7-	Pin 13	Channel 15-
Pin 14	Channel 7+	Pin 14	Channel 15+
Pin 15	Channel 8-	Pin 15	Channel 16-
Pin 16	Channel 8+	Pin 16	Channel 16+
Pin 17	-	Pin 17	-
Pin 18	-	Pin 18	-
Pin 19	-	Pin 19	-
Pin 20	-	Pin 20	-
Pin 21	-	Pin 21	-
Pin 22	-	Pin 22	-
Pin 23	-	Pin 23	-
Pin 24	-	Pin 24	-