The DeltaV mass termination blocks allow you to connect external marshalling panels and termination assemblies to your DeltaV system, significantly reducing wiring costs. The mass termination blocks provide a method to route the wiring within an enclosure and are used with low-level signals that are conducted over either 0.093 mm2 (28 AWG) off-the-shelf, flat ribbon cable or round instrument cable. For distances over 3 m, standard 20-pin round ribbon cable, 0.14 mm2 (26 AWG) is available. These mass termination blocks interface to a feed-through IDC-to-discrete-wire module such as the Phoenix Contact FLKM20 VARIOFACE ribbon connector module. For more information on these modules, visit the Phoenix Contact website. The Phoenix Contact FLKM20 VARIOFACE ribbon connector module is an Emerson Alliance Program product.
The 40-Pin Mass Termination Block interfaces to either the DI or DO Mass Connection Solutions through the same ribbon cable or round ribbon cable with 20-pin connectors.
If connectivity to IS barriers is required, additional HiD Series Boards from Pepperl+Fuchs are available. For more information on these Boards and Barriers, visit the Pepperl+Fuchs website. The HiD Series Boards from Pepperl+Fuchs are Emerson Alliance Program products.
Specifications
The above specifications might be more restrictive than the specifications listed for the DI, 8-channel, 24 VDC, Isolated card, the DO, 8-channel, 24 VDC, Isolated card, and the DO, 8-channel, 24 VDC, High-Side card.
