The table lists and defines the parameters a thermocouple input can have.
|
Parameter |
Can Configure? |
Description |
|---|---|---|
|
FIELD_VAL |
No |
The last value reported and the current status of the input. |
|
FIELD_VAL_PCT |
No |
The last value reported (in percent of range) and the current status of the input. |
|
LOCAL_CJT |
No |
The cold junction temperature as measured on the terminal block in degrees C. |
|
OVERRANGE_PCT |
Yes |
The percent value at which the analog value is considered overrange. If the signal is above this limit, its status indicates the value is limited high. |
|
UNDERRANGE_PCT |
Yes |
The percent value at which the analog value is considered underrange. If the signal is below this limit, its status indicates the value is limited low. |