Adding and starting a batch

Recipes built referencing a unit class must have the equipment bound to the step before that step will become active. You can select the equipment in the following ways:

• In the Unit Binding section on the Batch Creation dialog, select the units from the drop-down list.
• If you have not selected the equipment before starting the batch, the Unacknowledged Prompts button will flash on the toolbar when the equipment is needed by the phase. When you click the button, a dialog opens for you to select the equipment to be used. 

The OP_FINISH recipe is class-based and will run on one of the units in the BLENDER class. 

To be able to select equipment for a step in the Batch Operator Interface, the operator (or the user that is currently logged in) must have the BATCH_ADD key for the area containing the equipment that is required by the recipe. That area (containing the equipment) must be assigned to the same Batch Executive as the recipe. Therefore, if the equipment list is blank, either the unit class referenced by the recipe is not in the area assigned to the Batch Executive, or the user does not have the BATCH_ADD privileges for that area. (Function lock assignments are listed in the System Configuration/Setup/Security area of the DeltaV Explorer. User privileges are assigned in the DeltaV User Manager.)