Migrate from the DeltaV Continuous Historian to OSIsoft PI Server

After upgrading DeltaV on a system where you have been using the DeltaV Continuous Historian, you can migrate to OSIsoft PI Server by completing the following steps:

Upgrade DeltaV on the Application Station where you were using the DeltaV Continuous Historian.
If you plan to run PI Server on the Application Station in the DeltaV Area Control Network (ACN), complete step 2.a below. If you plan to run PI Server on a remote Application Station or a non-DeltaV workstation outside the DeltaV ACN, complete step 2.b below.
1. Install and configure PI Server and the PI Asset Framework (PI AF) Server on the Application Station in the DeltaV ACN according to the documentation provided by OSIsoft.
2. Install and configure PI Server and the PI AF Server on the remote Application Station or a non-DeltaV workstation outside the DeltaV ACN according to the documentation provided by OSIsoft.
Install the DeltaV Smart Connector on the Application Station in the DeltaV ACN according to the documentation provided by OSIsoft.
Enable PI Server in DeltaV Explorer by right-clicking the Continuous Historian subsystem under the Application Station where you installed the DeltaV Smart Connector, and then selecting Properties. On the General tab, select the Enabled check box, and then select the Use Enterprise Historian option.
Download the Application Station where you installed the DeltaV Smart Connector.

The configuration of the DeltaV Continuous Historian that you were previously using on the Application Station is preserved and migrated to the new installation of PI Server.

Important

Any historical data previously collected with the DeltaV Continuous Historian is not merged into the PI Server database. For more information, refer to the DeltaV Historian Upgrade Planning Guide white paper on the Emerson web site, also available from your Emerson field sales office or local business partner.